INSIDE

Apple explains how to clean your Vision Pro headset

Posted by Hartley Charlton

Apple today shared a detailed support document explaining how to clean your Vision Pro headset and all associated components.

To clean the Vision Pro screen protector, Apple simply recommends using a clean, dry microfiber cloth, such as the polishing cloth included with the headset. If necessary, users can also spray ZEISS cleaning fluid on a cloth before wiping down the Vision Pro.

Apple warns that the polishing cloth may attract particles that could scratch the Vision Pro if it is stored loose in a backpack. purse or pockets, and suggests that it should be stored in a clean bag. The polishing cloth can be machine washed and dried, or hand washed if needed to ensure it is clean enough to wipe down the headset.

Apple says that to clean the internal displays, users should first put on the Vision Pro cover and Place the headset on a flat surface. Then wipe the optical displays with a microfiber cloth, using ZEISS cleaning spray if necessary.

The ZEISS optical inserts must be removed from the Vision Pro before cleaning. They can be cleaned with ZEISS lens wipes, ZEISS cleaning spray or warm water. They should be completely dry before reattaching to the headset.

Users should use a lint-free cloth, soft-bristled brush, or non-stick tape to remove debris stuck to the curtain around the displays. Stains in this area can be removed by wiping with a damp cloth, but care should be taken not to get the displays wet.

To clean the Light Seal, Light Seal Cushion, headband, and cover, users can use mild dish soap. odor, but the use of cleaning, disinfecting wipes and washing powder should be avoided. 5 teaspoons (25 ml) of unscented dish soap should be mixed with two cups (500 ml) of warm water in a clean container before soaking the Light Seal, Light Seal Cushion, headband or case in liquid and gently rubbing the surface around two minutes. The item should then be removed and washed under running water, squeezing it to remove excess soap, and then left to dry at room temperature. It should not be used until it is completely dry.

Audio straps should be cleaned with a lint-free cloth. You can lightly dampen it with water and hypoallergenic soap, but be careful not to get in contact with the microphone, speakers, power jack, headband jack, and aluminum cover. It should be dried with a cloth before connecting to the main system. The speaker grilles can be cleaned with a dry cotton swab.

The disconnected battery can be cleaned with a damp, lint-free cloth, taking care not to get wet near the power cord connector. You can use a cloth dampened with soapy water to clean the power cord itself. It should be left to dry overnight before using it again with the Vision Pro.

Related Review: Apple Vision Pro Buyer's Guide: Vision Pro (Buy Now) Related Forum: Apple Vision Pro [26 comments]

Leave a Reply

Your email address will not be published. Required fields are marked *